beautypg.com

Ui timeout, Log level, Port 2301 – HP Serveur lame HP ProLiant BL680c G5 User Manual

Page 61: Multihomed certificate alternative names list

background image

UI Timeout

The UI timeout value represents the maximum amount of time in seconds that the HP SMH user
interface (UI) waits for data requested from webapps.

The UI timeout can be set in the range of 10 seconds to 3600 seconds.

Use the following command used to set the UI Timeout in seconds:

smhconfig - B|--ui-timeout[=] NUM

where, NUM is the value (in seconds) between the range 10 seconds to 3600 seconds.

The default UI Timeout value set is 120 seconds.

Log level

By default, the logging level of HP SMH error messages is set to error. When a log level is set,
all events that are the same or superior to the configured log level are written to the log file. The
log level option only affects the error_log file located under SystemDrive:\hp\hpsmh\logs
in Windows and under /var/spool/opt/hp/hpsmh/logs in Linux.

The following values are available, in order of decreasing significance:

Table 8 Log level

Description

Value

Emergencies - system is unusable

emerg

Action must be taken immediately

alert

Critical conditions

crit

Error conditions

error

Warning conditions

warn

Normal but significant condition

notice

Informational

info

Debug-level messages

debug

smhconfig -v|--log-level[=] logging-level

NOTE:

Log level only affects new messages written in the HTTP error log. You must perform a

soft restart of the system.

Port 2301

Port 2301 determines whether HP SMH listens on port 2301. If the value is set to True, HP SMH
listens on port 2301. If the value is set to False, HP SMH does not listen on port 2301.

The default is set to True.

smhconfig -T|--port2301[=] True | False

Multihomed certificate alternative names list

You can set the name for the certificate through the multihomed option.

It is important to restart the hpsmhd service when running smhconfig with multihomed values using
a single command on the console (--restart option).

smhconfig -u|--multihomed[=] NAMELIST

smhconfig -u|--multihomed[=] NAMELIST --restart

NAMELIST

must be a semicolon-separated list of IP addresses and hostnames.

UI Timeout

61

This manual is related to the following products: