APC UPS Network Management Card 2 AP9630 - Manual (Page 17)

Installation Manual 13
Command line interface
After you log on at the command line interface, as described in “Local access to
the command line interface” on page 11 or “Remote access to the command line
interface” on page 12, you can manually configure network settings.
1. Contact your network administrator to obtain the IP address, subnet
mask, and default gateway for the Network Management Card.
2. Use these three commands to configure network settings. (Text in italics
indicates a variable.)
a.tcpip -i yourIPaddress
b. tcpip -s yourSubnetMask
c. tcpip -g yourDefaultGateway
For each variable, type a numeric value that has the format
xxx.xxx.xxx.xxx
.
For example, to set a system IP address of 156.205.14.141, type the
following command and press
E NTER :
tcpip -i 156.205.14.141
3. Type exit. The Network Management Card restarts to apply the
changes.