HP Integrity rx4640 Server - Manual (Page 20)

Example 2:
/D
cqniccmd /D
Example 3:
/C
cqniccmd /Cc:\HP\teamcfg.xml
cqniccmd /C c:\HP\teamcfg.xml
cqniccmd /C”c:\HP\teamcfg.xml”
Example 4:
/P
cqniccmd /Pc:\HP\teamcfg.xml
cqniccmd /P c:\HP\teamcfg.xml
cqniccmd /P”c:\HP\teamcfg.xml”
Example 5:
/L
cqniccmd /Cc:\HP\teamcfg.xml /Lc:\HP\config.log
cqniccmd /C c:\HP\teamcfg.xml /L c:\HP\config.log
cqniccmd /C”c:\HP\teamcfg.xml” /L” c:\HP\config.log”
Command-line help
Use the following option to display usage information:
c/?
For example:
cqniccmd /?
This displays detailed usage information for the command.
Configuration properties
The XML data file contains configuration properties for individual NICs and for NIC teams.
NIC configuration properties
The properties configured on the target server NICs from the source server data are properties
that are common to all HP NICs.
These properties include the following:
•
SpeedDuplex — Determines the current speed and duplex of the NIC. Possible values
include Auto/Auto, 10/Half, 10/Full, 100/Half, 100/Full, and 1000/Full. The default is
Auto/Auto. The value must be valid for the NIC on the target system.
• PreferedPrimaryRanking — Determines the preferred primary ranking of the NIC. This
value is written only for NICs that are teamed.
• DualChannelGroup — If dual channel teaming is used, this identifies the group to which
the NIC belongs. The default is 0. This value is written only for NICs that are teamed. For
non-dual channel teams, the value is always 0.
• ConfiguredPortCost — Defines the port cost for the NIC. The default is 0. This value is
written only for NICs that are teamed.
• DefaultVlanID — Determines the VLAN ID used for any untagged packets received by the
NIC. This applies only to NICs that have VLANs defined.
20 Network Adapter Scripting Utility