HP L1506x 15-inch Non-Touch Monitor - Manual (Page 10)

3 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
Installing the Monitor Pedestal Base
To install the monitor pedestal base:
1. Place the pedestal base on your desktop or table and check to be sure the arrow on the
underside of the base is facing forward.
NOTE: Do not install the base if the monitor will be used on a wall, swing arm, or other
mounting fixture; instead refer to Mounting the Monitor on page 8 .
2. Using both hands, position the monitor over the pedestal base and press down firmly to lock the
pedestal base in place. When the base locks, it will make a clicking sound. Make sure the
pedestal base is securely locked before continuing with the setup.
Figure 3-1 Inserting the Monitor into the Pedestal Base
Connecting the Monitor
1. Place the monitor in a convenient, well-ventilated location near the computer.
2. Connect the monitor signal cable on the back of the monitor to the video connector on the rear
panel of the computer.
4 Chapter 3 Setting Up the Monitor ENWW