LG HR570S User Manual

Page 25

Installation

Ins
talla

tion

2. The [Connection Setting] menu appear on

the screen. Use

U/u to select [Wireless] and

press ENTER ( ).

3. Select [Yes] and press ENTER ( ) to

continue. The new connection settings
reset the current network settings.

4. The player scans all available access points

or wireless routers within range and displays
them as a list. Use

U/u to select an access

point or wireless router on the list, and then
press ENTER ( ).

If you have security on your access point
or wireless router, verify that the WEP or
WPA key that was entered into the player
matches the router’s information exactly.
You need to input the security code as
necessary.

NOTE

• WEP security mode generally have 4 keys

available on an access point or wireless router’s
setting. If your access point or wireless router
uses WEP security, enter the security code of the
key “No.1” to connect on your home network.

• An Access Point is a device that allows you to

connect to your home network wirelessly.

[Manual] – Your access point may not
be broadcasting its access point name
(SSID). Check your router settings through
your computer and either set your router
to broadcast SSID, or manually enter the
access point name (SSID) in [Manual].
[Push Button] – If your access point or
wireless router supports the Push Button
Configuration method, select this option
and press the Push Button on your access
point or wireless router within 120 counts.
You do not need to know the access point
name (SSID) and security code of your
access point or wireless router.

5. Use

U/u/I/i to select the IP mode

between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.

NOTE

If there is no DHCP server on the network and you
want to set the IP address manually, select [Static]
then set [IP Address], [Subnet Mask], [Gateway]
and [DNS Server] using

U/u/I/i and numerical

buttons. If you make a mistake while entering a
number, press CLEAR to clear the highlighted part.

6. Select [OK] and press ENTER ( ) to apply

network settings.