Alpine iDA-X100M - Manual (Page 7)

6
-EN
Accessory List
• Digital Media receiver........................................................1
• Power cable ........................................................................1
• Mounting sleeve.................................................................1
• Carrying case .....................................................................1
• Front frame.........................................................................1
• Bracket key.........................................................................2
• Screw (M5x8)......................................................................4
• USB cable ...........................................................................1
• iPod Dock interface cable .................................................1
• Cover sheet ........................................................................1
• Owner’s Manual .......................................................... 1 set
Turning Power On and Off
Press SOURCE to turn on the unit.
• The unit can be turned on by pressing any other button except
(Release), Double Action encoder and VIEW. The unit is also
automatically turned on if an iPod (USB connection) or USB memory
is connected.
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press (Release) at the lower left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the boat battery, etc.
1
Turn off the unit power.
2
Press (Release) to remove the front panel.
3
Press RESET with a ballpoint pen or similar pointed
object.
Adjusting Volume
Rotate the Double Action encoder until the desired
sound is obtained.
Setting the Time and Calendar
1
Press and hold FUNC./SETUP for at least 2 seconds
to activate the SETUP selection mode.
2
Rotate the Double Action encoder to select
“General”, and then press
/ENTER.
Bluetooth General Display iPod XM*
SIRIUS* HD Radio* Audio
* Only when HD Radio / SAT Radio receiver is connected.
3
Rotate the Double Action encoder to select Clock
Adjust, and then press
/ENTER.
The calendar setting mode is activated.
When the year is set, proceed step 5.
Getting Started
/ENTER
Double Action encoder
SOURCE
VIEW FUNC./SETUP