Audiovox NPD 5400 - Manual (Page 5)

IMPORTANT NOTES
A
Installation may only be carried out by trained specialists!
A
Observe all quality standards of the automobile industry!
A
Fire hazard! When drilling pay attention to the location of cable harnesses, tank and
fuel pipes!
A
Never drill into car parts which are load bearing or are important for safety reasons!
When installing components in the interior of the car remember the
following:
A
The driver’s field of vision must not be obstructed!
A
Increased risk of injury in accidents! Do not mount components in an area where the
airbag will inflate or where head or knees could impact in the event of an accident!
A
Installation may only be made in vehicles with 12 V board voltage and negative pole on
car body. Installation in unsuitable vehicles could result in malfunction, damage or fire!
System components
At least the following components are required for installation.
– Navigation computer with universal mounting frame and 2 release clips
– Mounting brackets and installation material
– GPS antenna with metal plate and cable
– Power supply cable
– Signal cable
– IR remote control
– Monitor with monitor cable
– Map DVD/CD and Operating Software CD
Take safety precautions
A
Before starting work disconnect the negative car battery terminal! When doing so
make sure to observe manufacturer’s safety instructions (alarm system, airbag, immobilizer,
radio coding, etc.)!
Installing metal sleeve, ill 1 - 2
The computer can be mounted in a DIN radio opening of the vehicle with the supplied
metal sleeve.
Please note before mounting, ill. 3:
– To ensure access to the DVD/CD opening a free space of at least 130 mm has to be
in front of the navigation computer.
– For sufficient air circulation a free space of at least 50 mm has to be behind the
navigation computer.
– A stable connection to the car body is necessary for the computer to function
correctly!
2
English