AT&T 1030 - Manual (Page 21)

Special Characters in Programmed Dialing Sequences
You may occasionally need to program a pause, stop, or switch-
hook flash into an Outside Auto Dial or Speed Dial sequence,
or you may need to switch from rotary to Touch-Tone signals in
the middle of a programmed dialing sequence. To do so, you
need to enter the following special characters when you pro-
gram the sequence.
Pause. To program a pause (1.5 seconds) into a dialing se-
quence (for example, between a pool access code and an out-
side telephone number):
Touch Hold (Pause).
Hold
●
●
●
Pause
Stop. To program a stop into a dialing sequence (for example,
to program a stop between an alternate long distance telephone
number and your access code):
Touch Drop (Stop). Drop
Stop
To resume the dialing sequence after the stop, touch the Auto
Dial button or dial the Speed Dial code again.
Touch-Tone Enable. To program Touch-Tone Enable into a dial-
ing sequence (for example, to use a credit card authorization
service):
Touch Transfer.
Transfer
Switchhook Flash. To program a switchhook flash into a dial-
ing sequence (for example, if you program a button with a PBX,
Centrex, or Custom Calling feature code):
20