LG 50PS80 - Manual (Page 10)

PREP
AR
AT
ION
9
ACCESSORIES
PREPARATION
Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the
dealer where you purchased the TV.
The accessories included may differ from the images below.
1.5V 1.5V
Owner’s Manual Power Cord Remote Control,
Batteries
FA V
MA RK
AV M OD E
PO
W ER Q. M EN U ME NU
WID GE TS
RE TU RN NE TC AS T
VO L
C H 1
2
3
4
5
6
7
8
0 9
FLASH BK
P A G E
IN PU T ENER GY SA VING
LIS T
ENTER
IN FO
CH AR /NU M DE LE TE
MUT E
AB C
DE F
GH I
W XY Z
TU V
PQ RS
MN O
JK L
RAT IO FRE EZE
CD Manual
O Op pttiio onn EExxttrraass
* Wipe spots on the exterior only with
the polishing cloth.
* Do not wipe roughly when removing
stain. Excessive pressure may cause
scratch or discoloration.
Polishing Cloth
Not included with all models
D-sub 15 pin Cable
When using the VGA (D-sub 15 pin
cable) PC connection, the user
must use shielded signal interface
cables with ferrite cores to maintain
standards compliance.
LLC CD D T TV V
Screws for stand assembly
(Refer to P.16)
Screw for stand fixing
(Refer to P.22)
Protection Cover
(Refer to P.17)
x 4
PPllaassm maa T TV V
Protection Cover
(Refer to p.15)
Cable management clip
(Refer to p.19)
Cable Holder
(Refer to p.19)
x 2
x 4
Screws for stand assembly
(Refer to P.14)
Ferrite Core
(Black)
(For 50PS80)
(For 60PS80)
(For 42LH50) (For 42LH50, 47LH50)
close to the wall plug.
Ferrite core can be used to reduce the elec-
tromagnetic waves that may interfere with the
TV. Install the Ferrite core on the power cable
close to the wall plug.
The ferrite core can be used to reduce the electromag-
netic waves in the S-VIDEO cable.
Wind the S-VIDEO cable on the ferrite core twice, and
then plug the cables into the TV as shown in the fol-
lowing picture.
Place the ferrite core close to S-VIDEO jack on the display.
Place the ferrite core close to
S-VIDEO jack on the display.
Ferrite Core
(White)