LG LP1411SHR - Manual (Page 10)

1
0
Press the POWER button to turn the air
conditioner ON or OFF. When you turn the air
c
tone will play and the LCD
display will show the set
temperature and any active
onditioner on, an ascending
mode.The air discharge on the top of the air
conditioner wil automatically open.
When turning the air conditioner off, you will
hear a descending tone and the air discharge
on the top of the air conditioner will close.
Any control settings such as Mode, Set
Temperature, Auto Swing, etc. will be retained
in memory when the power is off.
NOTE: When turned on after being unplugged,
the air conditioner will automatically reset to
COOL mo d e, with a temperature setting of 22°C .
Any settings will need to be re-entered.
POWER
Control panel buttons shown. Operation
using the remote control is the same, unless
specifically noted. NOTE:The remote sensor is
located under the air discharge and on the top
of the front panel.
Always point the remote at the sensor. The
remote may not work if the sensor is in bright
light or if there is not a clear path between the
remote and the sensor.
Press the MODE button to select the operating
mode(COOL,FAN,DRY , ENERGY SAVER or
HEAT)for the air conditioner.
And you can see the active
mode through the LCD Display.
The default setting is COOL.
Press the MODE button to
change to FAN, press again to change to DRY,
again to change to ENERGY SAVER,again to
change to HEAT, and again to return to COOL.
MODE
USING THE CONTROLS
Mode Features
COOL
(HEAT)
Compressor runs and cools(heats) the room. Use the
/ and FAN buttons to set the desired
temperature and circulation fan speed.
FAN Fan circulates air but compressor does not run.
Use the FAN button to set the desired fan speed.
DRY Dry mode is used to remove humidity from the room
without additional cooling. Once the set temperature
is reached, the compressor and circulation fan turns
off and only the exhaust fan will run. Fan speed is
pre-set and cannot be adjusted.
ENERGY
SAVER
Under normal operation, the exhaust fan cycles on
and off with the compressor, and the circulation fan
runs at the set speed.
The mode helps reduce power consumption by
automatically turning off the circulation fan as well
as the exhaust fan when the compressor is off. The
air conditioner will automatically cycle both fans on
and off with the compressor as needed for cooling.
H O W TO U S E
COOL FAN
DRY
→
→
ENERGY
SAVER
→
HEAT
→