Presentation timer function, Using keystone function – LG DX630-JD User Manual

Page 26

Function

1. Press the TIMER button of remote control.

2. Press the

button to select

Time alarm

Time keeper

item.

3. Press the

button to select the desired preset time.

4. The timer starts to operate if you select specific time.

●

Time alarm function : If you select a specific time, it is displayed in minute units. After 1 minute, the remaining

time is displayed at the bottom right of the screen, and then disappears after 5 seconds.
When the remaining time is displayed, other OSD windows are closed. When the set
time is reached, ‘0 minute’ flickers 10 times at 1 second intervals, and then disappears.

●

Time keeper function : If you select a specific time, it continues to be displayed in minute(‘) and second(“)

units. Even though other OSD windows appear, the remaining time is displayed again
after the windows are closed. When the set time is reached. 0’ 00” flickers 10 times at
1 second intervals, and then disappears.

5. If the set time disappears because of the use of other menus, press the Timer button on a remote to

display the set time again.

●

The

Time alarm

function and the

Time keeper

function cannot be used at the same time.

●

The

Time alarm

function can be set from 5 to 60 minutes at 5 minute intervals (Off, 5, 10, 15, 20, ..............,

55, 60 minutes).

●

The

Time keeper

function can be set from 1 to 10 minutes at 1 minute intervals, and from 10 to 60 minutes

al 5 minute intervals (Off, 1, 2, 3, 4, .............., 8, 9, 10, 15, 20, 25, .............., 55, 60 minutes).

●

You can use this function through the MENU button.

●

Press the EXIT button to exit the menu screen.

Presentation timer Function

1. Press the KEYSTONE button of remote control.

2. Press the

button to adjust the screen condition as you want.

●

Keystone

can be adjusted from -20 to 20.

●

You can use the Keystone function on the menu screen by pressing the
MENU button, or by pressing the Keystone + and Keystone – buttons on the
control panel.

●

Press the MENU button twice or the EXIT button to exit the menu screen.

Using Keystone Function

* Use this function when the screen is not at a right angle to the projector and the image is a trapezoid shape.
* Only use the Keystone function when you can’t get the best angle of projection.

Keystone

Exit Adjust

Time alarm

Time Keeper

Off

Exit Move Select