Alliance Laundry Systems Frontload Washer - Manual (Page 12)

-12-
802753
There is no agitator on this washer. Instead, the
clothing gently tumbles through the water. The
wash action consists of a period of tumbling in
one direction, a brief pause, and then a reverse
tumble in the opposite direction. The pauses are
part of the tumble action and add to the unique
cleaning capabilities of the washer. They are part
of the cycle.
NOTE: There will be extended pauses when
Boosted Hot Wash, if available, is selected
because the water is being heated.
To Change Cycles
If the selected cycle is not the correct cycle for
the fabric being washed, you may change the cycle
selection at any time until the first wash fill is
complete. Once the washer has filled for the first
part of the cycle (the wash portion), the current
cycle must be aborted and a new cycle must be
started.
To change the cycle before the first fill is
complete:
Change the cycle selected on the cycle selector
knob.
To change the cycle after the first fill is
complete and before the first wash is complete:
1. Abort the current cycle by changing the
cycle selector knob to the OFF position.
2. Set the WASH/RINSE temperature selector.
3. Set cycle selector knob.
4. Turn on extra rinse, if desired.
5. Press and hold the START button for two
seconds.
To change the cycle after the first wash is
complete:
NOTE: This should only be done if the speed of
the final extract is incorrect for the fabric being
washed. For example, if washing delicate items
on the REGULAR cycle, the high speed extract
may damage the fabric. Or, if washing towels or
jeans on the DELICATE cycle, the lower speed
extract would increase drying time.
1. Abort the current cycle by changing the
cycle selector switch to the OFF position.
2. Restart the cycle from the beginning. Refer
to the To Wash Clothes section.
To Pump Out Water After Aborting Cycle
Run a SPIN ONLY cycle. This cycle will perform a
high speed extract operation that will pump all of
the water out of the washer.
Manual Soaking
To soak a clothes load, start a wash in the
desired cycle. After fill is complete and wash drum
has started tumbling, turn the cycle selector
knob to OFF. When the clothes have soaked the
desired length of time, turn the cycle selector
knob to the cycle and press the start button to
restart the cycle.