Alliance Laundry Systems Frontload Washer - Manual (Page 11)

-11-
802753
4. Close the loading door tightly. The washer will
not operate with the loading door open.
5. Set WASH/RINSE temperatures.
There are four or five WASH/RINSE temperatures
available – Boosted Hot Wash/Cold Rinse (select
models only), Hot Wash/Cold Rinse, Warm Wash/
Warm Rinse, Warm Wash/Cold Rinse, Cold Wash/
Cold Rinse.
Refer to the Water Temperature section for the
temperature that works best for your garments.
6. Select EXTRA RINSE if desired.
The extra rinse control is useful for detergent
sensitive skin. By pressing the EXTRA RINSE to
ON, the REGULAR, PERMANENT PRESS, and
DELICATE cycles will each provide an additional
rinse. If the rinse is desired, press the switch to
ON. When the extra rinse is not wanted, OFF
should be selected.
7. Select the cycle according to the type of
fabric being washed. Use the indicator dot on
the cycle selector knob as a guide.
8. Press and hold the START button for two
seconds to start the washer. The DOOR light
will come on after a short delay, water fill will
begin, and wash drum will begin tumbling.
NOTE: Washer door MUST be closed tightly to
start washer.
If items need to be added or removed after a cycle
has started, turn the cycle selector knob to the
OFF position. Wait until the DOOR light goes off
(approximately 45 seconds after cycle has been
stopped), open door, add or remove items, and
start the cycle again.
FLW2171N
FLW2174N
To reduce the risk of serious injury, do
not bypass the loading door switch by
permitting the washer to tumble or spin
with the loading door open.
W095
W A R N I N G
W A R N I N G
Window may be hot in the Boosted Hot
and Hot wash cycles.
W325
FLW2175N