Alpine CDA-7998 - Manual (Page 21)

19
-EN
Setting the AUX Mode (V-Link)
You can input TV/video sound by connecting an optional
Ai-NET/RCA Interface cable (KCA-121B) or Versatile
Link Terminal (KCA-410C) to this component.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select the AUX
mode.
3
Press the BAND button to toggle the mode between
ON and OFF.
NOTES
• The initial setting at the factory is OFF.
• You can set the AUX mode display by pressing the
g DN or f UP button after ON is set, select the AUX
mode display setting, and then press the BAND button.
• When connecting the KCA-410C, you can set two AUX mode
displays.
4
Press the SETUP button to return to normal mode.
5
To adjust the volume, etc., first press the SOURCE
button and select the AUX mode, then make the
necessary adjustment.
NOTE
When using the Versatile Link Terminal (KCA-410C), you can
connect two external inputs. To select the mode, press the BAND
button on the unit.
Connecting to an External Amplifier
(CDA-7897 only)
When an external amplifier is connected, sound quality
can be improved by stopping the power supply of the
built-in amplifier. The power output is set to OFF by the
following procedure.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select "P-IC".
3
Press the BAND button to toggle the mode between P-
IC ON and P-IC OFF.
P-IC OFF:
In this mode, use the front and rear pre-amplifier of the
unit, connected to an external amplifier to drive
speakers. In this setting, nothing is output from the
unit’s internal amplifier.
Amplifier
Amplifier
Front
left
Front
right
Rear
left
Rear
right
P-IC ON:
The speakers are driven by the built-in amplifier.
NOTE
No sound is produced by the system when the power output is set
to OFF.
4
Press the SETUP button to return to normal mode.
Setting the Defeat Mode External
Interrupt
When interrupting external devices to this unit, turning
DEFEAT ON will bypass BASS, TREBLE and MX for the
external interrupt.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select the
INTERRUPT mode.
3
Press the BAND button to toggle the mode between
ON and OFF.
When using Initial mode, set this to OFF.
When the Initial mode is not selected, set this to OFF.
4
Press the SETUP button to return to normal mode.
Speakers
Front
left
Front
right
Rear
left
Rear
right
SPEAKER
RIGHT FRONT
SPEAKER
RIGHT REAR
SPEAKER
LEFT REAR
SPEAKER
LEFT FRONT