American Dryer Corp. Gas- DSI/Steam ML-82 II User Manual

Page 44

SECTION VII

PROCEDURE FOR FUNCTIONAL CHECK

OF REPLACEMENT COMPONENTS

1. Microprocessor Controller (Computer) Board

a. Upon completing installation of the replacement microprocessor controller (computer) board, reestablish

power to the dryer.

b. Start the drying cycle by pressing any of the preset cycles in letters A-F.

c. Verify that the motor(s) and the heat indicator dots, in the microprocessor controller (computer) light

emitting diode (L.E.D.) display are on. (Refer to the illustration below.)

1) Basket (tumbler) in Forward Mode (clockwise [CW]) indicator

2) Basket (tumbler) in Reverse Mode (counterclockwise [CCW]) indicator (for Reversing Models

Only)

3) Heat On indicator

4) On indicator (dryer is in Operation Mode)

5) Air Jet indicator (for applicable models with optimal air jets)