Installation, 1 closing the door, 1 positioning – Electrolux EN3480AOX User Manual
Page 39

Problem
Possible cause
Solution
The temperature in
the refrigeration is
too high.
There is no cold air circu-
lation in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high.
Products are too near to
each other.
Store products so that
there is cold air circulation.
The appliance does
not operate.
The appliance is switched
off.
Switch on the appliance.
The mains plug is not con-
nected to the mains sock-
et correctly.
Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no voltage
in the mains socket.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
The lamp does not
work.
The lamp is in stand-by.
Close and open the door.
"dEMo" appears on
the display.
The appliance is in dem-
onstration mode.
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the dis-
play shut off for a short
while: appliance start works
regularly.
The buzzer sounds.
The Display is red..
The door is not closed
correctly.
Refer to "Door open
alarm".
Upper or lower
square is shown in
the temperature dis-
play.
An error has occurred in
measuring the tempera-
ture.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
As much as the advice does not lead to result, call the nearest brand-mark service.
7.1 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
ENGLISH
39