Electrolux EHF3320FOK - Manual (Page 25)

Problem Possible cause Remedy
The STOP+GO function
operates. Refer to the chapter “Daily
Use”.
There is water or fat
stains on the control pan-
el. Clean the control panel.
An acoustic signal
sounds and the appli-
ance deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor
fields. Remove the object from
the sensor fields.
The appliance deacti-
vates. You put something on
the sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
The Automatic Heat Up
function does not oper-
ate. The cooking zone is hot. Let the cooking zone be-
come sufficiently cool.
The highest heat setting
is set. The highest heat setting
has the same power as
the Automatic Heat Up
function.
You decreased the heat
setting from
.
Start from and only in-
crease the heat setting.
You cannot activate the
outer ring. Activate the inner ring first.
The sensor fields be-
come hot. The cookware is too
large or you put it too
near to the controls. Put large cookware on the
rear cooking zones if nec-
essary.
comes on. The Automatic Switch Off
operates. Deactivate the appliance
and activate it again.
comes on. The Child Safety Device
or the Lock function op-
erates. Refer to the chapter “Daily
Use”.
and a number come
on.
There is an error in the
appliance. Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If
comes
on again, speak to the
service centre.
If you tried the above solutions and can-
not repair the problem, speak to your dealer or the customer service. Give the
data from the rating plate, three digit letter
ENGLISH 25