Electrolux EDE1074PDW - Manual (Page 17)

Warning! It is important not to connect
the vent hose to, for example, a cooker
hood, or a chimney or flue pipe
designed to carry the exhaust from a
fuel burning appliance.
Note that to avoid condensation problems,
it is essential that the dryer be fitted with the
flexible hose to carry its “exhaust” at least
beyond the kitchen units; preferable outside
the kitchen. In order to prevent the appli-
ance from overheating, it is important that
the steam exhaust is unobstructed. There-
fore, in case of a permanent hose fitted to
an exterior wall or ceiling, it must be ensur-
ed an exhaust capacity of at least 150 m3/
h. If the dryer is fitted next to kitchen units,
make sure that the vent hose is not
squashed. If the hose is partially squashed,
drying efficiency will be reduced, resulting in
longer drying times and higher energy con-
sumption. If the hose is completely squash-
ed, the safety cut-outs with which the ma-
chine is fitted may operate. When operating
the tumble dryer, the room temperature
must not be lower than +5°C and higher
than +35°C, as it may affect the perform-
ance of the appliance.
DOOR REVERSAL
To make it easier to load or unload the
laundry, the door can be reversed. The
door must only be reversed by an author-
ised service engineer. Please contact your
local Service Force Centre. The engineer
will carry out the door reversal at your cost.
ELECTRICAL CONNECTION
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see “Product de-
scription” chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer
declines any responsibility for
damage or injury through failure to
comply with the above safety
precautions.
Should the appliance power supply
cable need to be replaced, this
must be carried out by our Service
Center.
Warning! The plug must be
accessible after installing the
machine.
SPECIAL ACCESSORIES
Stacking kit
A special stacking kit is available through
your dealer, to enable the mounting of the
dyer on top of a front loading washing ma-
chine with cover’s depth between 48 and
60 cm. Read carefully the instructions sup-
plied with the kit.
electrolux 17