beautypg.com

Asus WIFI-AP P5E3 User Manual

Page 50

background image

2-24

Chapter 2: Hardware information

16. USB 2.0 ports 3 and 4. These 4-pin Universal Serial Bus (USB) ports are

available for connecting USB 2.0 devices.

17. Optical S/PDIF Out port. This port connects an external audio output device

via an optical S/PDIF cable.

18. USB 2.0 ports 5 and 6. These 4-pin Universal Serial Bus (USB) ports are

available for connecting USB 2.0 devices.

• DO NOT insert different connectors to the external SATA ports.
• DO NOT unplug the external Serial ATA box when a RAID 0 or RAID 1 is

configured.

• Before creating a RAID set using Serial ATA hard disks, make sure that you

have connected the Serial ATA signal cable and installed Serial ATA hard

disk drives; otherwise, you cannot enter the JMicron RAID utility and SATA

BIOS setup during POST.

• If you intend to create a RAID configuration using this connector, set the

J-Micron eSATA/PATA Controller Mode in the BIOS to [RAID]. See section

4.5.3 Onboard Device Configuration for details.

• When using hot-plug and NCQ, set the J-Micron eSATA/PATA Controller

Mode in the BIOS to [AHCI]. See section 4.5.3 Onboard Device

Configuration for details.

• Before creating a RAID set, refer to 5.4.3 JMicron

®

RAID Configuration or

the manual bundled in the motherboard support DVD.