Bosch HUI54451UC - Manual (Page 8)

8
appliance must agree with the electrical installation (see
rating plate).
The appliance complies with protective class I and may
only be operated with a PE conductor connection.
The installation must contain a disconnector with a
contact opening of at least X ” (3 mm) that isolates all
poles from the mains. It must still be accessible after
installation.
Only an electrical specialist may lay or replace the
connecting lead, paying attention to the applicable
regulations.
If the mains connecting lead of this appliance is
damaged, it must be replaced with a special connecting
lead, which is obtainable from the manufacturer or the
manufacturer's after-sales service.
Before You Begin
Tools and Parts Needed
▯
Measuring tape
▯
Pin
▯
Phillips screwdriver (Posidrive) #2
▯
Drill with the following bits: 3 /
16
" (5 mm)
▯
Spirit level
▯
Aluminum tape (DO NOT use insulating tape)
▯
Exhaust air duct (configuration depends on the
installation situation)
▯
Additional sheet metal screws (if necessary for
installation of the exhaust air duct)
▯
Jigsaw
Parts Included
Appliance dimensions
èç¼ʀɿ
PP
‘ë
PP
èç¼ɾʃ
PP
ɻ¼ɾʃ
PP
èç¼ɾʃ
PP