Electrolux ENN2911AOW - Manual (Page 14)

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The temperature in
the refrigerator is too
high. There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that there
is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed cor-
rectly. Refer to "Closing the door".
The temperature regulator
is not set correctly. Set a higher temperature.
REPLACING THE LAMP
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp cov-
er.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown on
the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
14 www.electrolux.com