Electrolux ZCS2100 - Manual (Page 6)

8
7 5 6 4
1 2 3
12 13
11 8 9 10
English
GETTING THE BEST RESULTS
Use the nozzles as follows:
Carpets: Use the carpet/hard floor nozzle with the lever in posi-
tion (1). Reduce suction power for small carpets.
Hard floors: Use the carpet/hard floor nozzle with the lever in
position (2).
Wooden floors: Use the parquet nozzle (certain models only, 3).
Upholstered furniture: Use the combination nozzle as shown in
(4).
Curtains, lightweight fabrics, etc.: Use the combination nozzle
as shown in (4). Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the combination nozzle as
shown in (5) or Easy clean (6 – certain models only).
Crevices, corners, etc.: Use the crevice nozzle (7).
Using the power nozzle
(Requires an Ultra Silencer equipped with a power socket. The power
nozzle is delivered only with certain models, or could be bought as an
accessory.)
8 Attach the nozzle to the tube.
9 Connect the power nozzle to the socket on the vacuum
cleaner.
10 Use the clips to secure the cable along the tubes and
hose.
11 The power nozzle starts operating when the vacuum
cleaner is switched on.
Using the turbo nozzle
(certain models only)
12 Attach the nozzle to the tube.
13 Adjust the suction power by opening or closing the air
vent.
Note: Do not use the power or turbo nozzle on skin rugs, rugs with
long fringes or a pile depth exceeding 15 mm. To avoid damaging the
carpet, do not keep the nozzle stationary whilst the brush is rotating.
Do not pass the nozzle across electric cables, and be sure to switch off
the vacuum cleaner immediately after use.