Electrolux EN3881AOX - Manual (Page 20)

8.2 Rear spacers
2
4
3
1
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
8.3 Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
8.4 Installation of the CleanAir Control filter
The CleanAir Control filter is an active car-
bon filter which absorbs bad odours and
permits to maintain the best flavour and
aroma for all foodstuffs without risk of
odour cross contamination
On delivery the carbon filter is in a plastic
bag to maintain it’s duration and charac-
teristics. The filter should be placed be-
hind the flap before the appliance is
turned on.
1. Open the flap cover.
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
back of the flap cover.
4. Close the flap cover.
The filter should be handled care-
fully so fragments do not loosen
from the surface. The filter should
change once every six months.
8.5 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
20 www.electrolux.com