Electrolux EI23CS35KB - Manual (Page 10)

10 Installing Door Handles
Door Handle Mounting Instructions
1 Remove handles from carton and any other protective
packaging.
2 Position freezer handle end caps over upper and
lower pre-installed shoulder bolts (A) that are fastened
into door, ensuring the holes for the set screws are
facing towards the refrigerator door.
3 While holding handle firmly against door, fasten upper
and lower Allen set screws (B) with supplied Allen
wrench.
4 Repeat steps 2 and 3 to install refrigerator handle.
Ensure the holes for the set screws are facing towards the freezer door.
A
B
Freezer Lower End Cap
A
B
Refrigerator Lower End Cap
A
B
Freezer Upper End Cap
A
B
Refrigerator Upper End Cap
NOTE
All set screws should be tightened and sub-flush (Allen set screw should be seated just below
the surface of the end cap) of handle end cap. The end caps should be drawn tight to freezer and
refrigerator doors with no gaps.