Alto-Shaam Halo Heat 300-HW/D6 User Manual
Page 15
Hot Food Drop-In Well Operation & Care Manual • 14
C A R E A N D C L E A N I N G
INTERIOR:
1. Disconnect appliance from the power source.
Let unit cool.
2. After the appliance has cooled, remove all
detachable items such as pans and divider bars.
Clean these items separately.
3. Remove any food scraps.
4. Wipe the interior metal surfaces with a paper
towel to remove any remaining food debris.
5. Clean interior with a damp cloth or sponge
and any good commercial detergent at the
recommended strength.
6. For baked-on food deposits, use a non-caustic
and non-toxic commercial oven cleaner
appropriate for the interior surface. Follow
the product manufacturer's instructions
carefully for the use of this product. Any
commercial oven cleaner must be approved
for use on food contact areas. Remove soil
with the use of a plastic scouring pad.
7. Rinse surfaces by wiping with a clean cloth or
sponge and clean warm water.
8. Remove excess water with a sponge and wipe
dry with a clean cloth or air dry. Leave area
open until interior is completely dry. Replace
divider bars and pans.
9. Interior can be wiped with a sanitizing
solution after cleaning and rinsing. This
solution must be approved for use on stainless
steel food contact surfaces.
DO NOT USE ABRASIVE CLEANING COMPOUNDS.
Always follow appropriate state or local health
(hygiene) regulations regarding all applicable
cleaning and sanitation requirements for food
service equipment.
NOTE:
Always allow the appliance
to cool before cleaning.
C L E A N T H E A P P L I A N C E D A I LY.
NOTE:
Completely avoid the
use of abrasive cleaning
compounds, chloride-based
cleaners, or cleaners
containing quaternary salts.
To protect metal finish on
stainless steel, never use
hydrochloric acid (muriatic
acid).
The cleanliness and
appearance of this appliance
will contribute considerably
to operating efficiency and
savory, appetizing food.
Good equipment kept clean
works better and lasts
longer.
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
D A N G E R
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED