Nilfisk-ALTO SR 1301 B - Manual (Page 80)

ENGLISH USER MANUAL
18 1463436000(1)2008-05 A SR 1301 B
AFTER USING THE MACHINE
After working, before leaving the machine:
Turn on the fi lter shaker shortly, by pressing the upper part of the switch (56). –
Empty the hopper (4) (see the procedure in the previous paragraph). –
Lift the main broom with the lever (73). –
Lift the side brooms with the levers (70) and (71). –
Turn off the machine by turning the ignition key (67) to “0”, then remove it. –
Engage the parking brake by pressing the pedal (75), then engage the brake lock control lever (68). –
WORKING LIGHT ADJUSTMENT
If necessary, adjust the working light beam aiming (9) with the screws (21).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Check that the machine storage area is dry and clean. –
Disconnect the battery connector (25). –
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Before performing any maintenance procedure, carefully read the instructions shown in Safety chapter.