Nilfisk-ALTO SR 1301 B - Manual (Page 76)

ENGLISH USER MANUAL
14 1463436000(1)2008-05 A SR 1301 B
USE
10 11
12
69
68
70
13 36 37
25
73 72
24
75
66
65
71
67
60
56
64
61 62 63
P100246
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER –
WARNING –
CAUTION –
CONSULTATION –
While reading this Manual, the operator must pay careful attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualifi ed personnel only. According to the type of batteries
(WET or GEL), set the electronic board of the machine.
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires one 24 V battery, or four 6 V batteries in serial connection.
The machine can be supplied in one of the following confi gurations:
Batteries already installed and ready to be used a)
Batteries installed on the machine but without electrolyte b)
Without batteries c)
According to machine confi guration, proceed as follows.
Batteries already installed and ready to be used a)
Open the hood (13) and engage the hood support rod (36). 1.
Check that the batteries are connected to the machine with the connector (25). 2.
Disengage the support rod (36) and close the hood. 3.
Insert the ignition key (67) and turn it to “I”, without pressing the pedal (69). 4.
If the green warning light (63) turns on, the batteries are charged.
If the yellow (62) or red (61) warning light turns on, the batteries must be charged (see the procedure in Maintenance
chapter).