American DJ Alpha Moon - Manual (Page 4)

To next fixture or terminate
From DMX Controller
ON 1 2 3 4 5 6 7 8 9 10 ON 1 2 3 4 5 6 7 8 9 10 ON 1 2 3 4 5 6 7 8 9 10
© American DJ Supply ® - www.americandj.com - Alpha Moon™ Instruction Manual Page 7 © American DJ Supply ® - www.americandj.com - Alpha Moon™ Instruction Manual Page 8
1. MINI/C Controller Jack - This is for use the optional MINI/C Black
out controller only. Do not attempt to connect an audio signal
this jack, this will damage the PC board and void your manufac-
tures warranty!
2. Dip Switches - These switches are used to set the DMX address.
Each switch corresponds to a specific value based on binary code.
See page 6 for a detailed explanation of DMX binary code.
3. Cooling Fan - Keep the fan grill clean. Never block the fan vents,
always allow at least four inches between the fan and any other sur-
face. Improper cooling may result in premature lamp failure.
4. Thumb Screw - This screw hold the lamp cover in place. Remove
this screw to access the lamp compartment.
5. Power Indicator - This LED will flash when it receives either an
audio or DMX signal.
6. XLR Output Jack - This jack is used to send the incoming DMX
signal to another DMX fixture.
7. XLR Input Jack - This jack is used to accept an incoming DMX
signal.
8. Power Cord - Connect only to a matching power outlet. Never use
this fixture is the ground prong has been removed or broken off.
For a more dramatic effect, link several Alpha Moons together.
Alpha Moon™ Linking
Linking: Your fixture comes with a built-in controller. This controller
may be used to control up to 16 units when daisy-chained together in
a master-slave configuration. Any unit can function as either a “Master
Unit” or a “Slave Unit.” Link the units together using standard DMX
cable.
Alpha Moon™ Controls and Functions
ON 1 2 3 4 5 6 7 8 9 10
1 9 8 7 6 5 4 3 2 11 10