ATEN CS-9134 - Manual (Page 14)

4. Plug the power adapter cable into the Master View’s Power Jack, then plug
the adapter into an AC power source.
5. Repeat these steps for any other Third Stage units you wish to connect.
6. Plug in the power adapters for all the Second Stage Master View units.
7. Plug in the power adapter for the First Stage Master View unit.
8. Turn on the power to all the computers.
Note: The Power On sequence requires that all Third Stage units be
powered on first. After they are all on, the Second Stage units must be
powered on next. After all the Second Stage units are on, the First
Stage unit must be powered on. Only after all the Master Views have
been powered on in this sequence, can the computers be powered on.
2005-12-21
10 CS-9134 / CS-9138 User Manual