Agri-Fab 45-02113 - Manual (Page 6)

6
17. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the rod through the slot in the flow
control mounting bracket and through the hole in the
flow control link. Secure with a 3/32" x 3/4" cotter pin.
See figure 8.
FIGURE 8
18. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 9.
FIGURE 9
19. Assemble the flow control mounting bracket to the hitch
tube using two 1/4" x 1-3/4" hex bolts, six 5/16" flat
washers and two 1/4" hex lock nuts as shown in figure
10.
Do not tighten at this time.
FIGURE 10
20. Place the adjustable stop into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a 5/16"
flat washer and the nylon wing nut. See figure 11.
FIGURE 11
5/16" FLAT
WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
NYLON
WING NUT
ADJUSTABLE
STOP
FLOW
CONTROL
ROD
FLOW
CONTROL
LINK
3/32"
COTTER
PIN
5/16" FLAT
WASHER
SLOT
FLOW CONTROL
MOUNTING BRACKET
1/4" x 1-3/4"
HEX BOLT
1/4" HEX
LOCK NUT
5/16" FLAT
WASHER
5/16" FLAT
WASHER