Asus M2N-MX SE - Manual (Page 36)

1-26 Chapter 1: Product introduction
3. Serial ATA connectors
(7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA
3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3 Gb/s is
backward compatible with Serial ATA 1.5Gb/s specification.
The current Serial ATA I interface allows up to 150 MB/s data transfer
rate while Serial ATA II allows up to 300 MB/s data transfer rate,
faster than the standard parallel ATA with 133 MB/s (Ultra DMA133).
If you install Serial ATA hard disk drives, you can create a RAID
0, RAID 1, and JBOD configuration through the onboard NVIDIA ®
MediaShield™ controller.
Important note on Serial ATA
Install the Windows
® 2000 Service Pack 4 or the Windows ® XP Service
Pack1 before using Serial ATA.
• For detailed instructions on how to configure RAID 0, 1, and
JBOD, refer to the RAID manual in the support CD.
• The RAID function of these connectors is set to [Disabled] by
default. If you intend to create a Serial ATA RAID set using these
connectors, enable the RAID Enabled item in the NVRAID
Configuration sub-menu in the BIOS. See section “2.4.3 Onboard
Device Configuration” for details.
M2N-MX SE
R
M2N-MX SE SATA Connectors
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1