Alpine CDA-7876RB - Manual (Page 21)

19
-EN
RDS
Receiving Traffic Information
1
Press the T.INFO button to activate the Traffic
Information mode.
To cancel the Traffic information mode, press the
T.INFO button again.
2
Press the g DN or f UP button to select
your desired traffic information station. When a
traffic information station is tuned in, the TP
indicator lights up.
Traffic information is heard only when it is being
broadcast. If traffic information is not being
broadcast, the unit is set in the standby mode.
When a traffic information broadcast begins, the
unit automatically receives it and the display
shows "TRF-INFO" for 5 seconds, then returns
to the previous display.
When traffic information broadcast is over, the
unit will automatically set in the standby mode.
NOTES
•
If the traffic information broadcast signal falls below a
certain level, the unit remains in the receiving mode
for 1 minute. If the signal remains below a certain
level for over 1 minute, the "T.INFO" indicator blinks.
•
If you do not want to listen to the traffic information
being received, lightly press the T.INFO button to skip
that traffic information message. The T.INFO mode
will remain in the ON position to receive the next
traffic information message.
•
If the volume level is changed while receiving traffic
information, the changed volume level will be
memorized. When traffic information is received next
time, the volume level will be automatically adjusted
to the level memorized.
•
In the T.INFO mode, the SEEK tuning selects only the
TP stations.
PTY (Programme Type) Tuning
1
Press the "F" button. The indicator will
illuminate.
2
Press the PTY button to activate the PTY mode.
The Programme Type of the station being
currently received will be displayed for 5
seconds.
•
If there is no receivable PTY broadcast, "NO
PTY" will be displayed for 5 seconds.
•
If no RDS station can be received, the display
shows "NO PTY."
NOTE
If no button is pressed within 5 seconds after pressing the
PTY button, the PTY mode will be automatically
cancelled.
3
Press the g DN and f UP buttons within 5
seconds after activating the PTY mode to
choose the desired programme type while the
PTY (programme type) is being displayed. Each
press scrolls the programme type by one.
→
LIGHT M
→
CLASSICS
→
OTHER M
4
Press the PTY button within 5 seconds after
selecting the programme type to start searching
for a station in the selected programme type.
The chosen programme type indicator blinks
during searching and lights when a station is
found.
If no station is found, "NO PTY" will be displayed
for 5 seconds.
5
Press the "F" button to activate the normal mode.
The
indicator will turn off.
NOTE
Operate the unit while the indicator is illuminated.
If no buttons are pressed within 5 seconds, the
indicator will turn off.