TOHO ELECTRONICS TTM200 - Manual (Page 5)

5
2. Settings regarding TOHO communications
2.1 Overview
Before communications is performed, initial settings must be made on this product. Enter such
settings with the keys on the front panel.
To switch to a series of setting screens, take the steps described below.
For details, see the operation manual furnished with this product.
Setting item selection mode
Communication protocol setting
0: TOHO communication protocol
Communication parameter setting
Communication speed setting
Communication address setting
Response delay time setting
Communications switchover setting
Back to setting item selection screen
MODE key
MODE key
MODE key
MODE key
MODE key
MODE key
MODE key
Power-on
Initial setting
4 seconds
Operation mode screen
MODE key at least 2 seconds
Setting item selection mode
▲/▼ key
When the settings are over, press the MODE key at least 2 seconds to go back to the operation mode.
The parameters indicated above are initial values.