Sterlco SDA Series Medium Capacity Dehumidifying Dryer - Manual (Page 44)

Cabinet Series Dehumidifying Dryer 44
Level 1 AL-2 Alarm Value 2 -1999 to 9999 EU 0 25.0
Level 1 AL-3 Alarm Value 3 -1999 to 9999 EU 0 Default
Level 1 P Proportional Band 0.1 to 999.9% FS 10.0 4.4
Level 1 I Integral Time 0 to 3999 SEC 233 84
Level 1 d Derivative Timer 0 to 3999 SEC 40 13
Level 1 C-SC Cooling
Coefficient
0.01 to 99.99 1.00 Default
Level 1 C-db Dead Band -19.99 to 99.99%FS 0.00 Default
Level 1 6F-r Manual Reset
Value
0.0 to 100.0% 50.0 Default
Level 1 HYS Hysteresis (Heat) 0.01 to 99.99%FS 0.10 Default
Level 1 CHYS Hysteresis (Cool) 0.01 to 99.99%FS 0.10 Default
Level 1 CP Control Period
(Heat)
1 to 99 SEC 20 Default
Level 1 C-CP Control Period
(Cool)
1 to 99 SEC 20 Default
Mode Parameter Setting range Default Factory
setting
Level 2 r-L Remote/Local RMT/LCL LCL Default
Level 2 SPrU Sp Ramp Time Unit M(Minutes)/H(Hours) M Default
Level 2 SPrE Sp Ramp Set Value 0 to 9999 EU 0 Default
Level 2 LbA LBA Detection Time 0 to 9999 SEC 0 Default
Level 2 Au-5 MV at Stop -5.0 to 105.0% 0.0 Default
Level 2 Au-E MV at PV Error -5.0 to 105.0% 0.0 Default
Level 2 6L-L MV Upper Limit MV Lower Limit +0.1 to 105.0% 105.0 Default
Level 2 6L-L MV Lower Limit -5.0 to MV Upper Limit –0.1% -5.0 Default
Level 2 6rL MV Change Rate Limit 0.0 to 100.0%/SEC 0.0 Default
Level 2 CnF Input Digital Filter 0 to 9999 SEC 0 Default
Level 2 ALH1 Alarm 1 Hysteresis 0.01 to 99.99% 0.02 Default
Level 2 ALH2 Alarm 2 Hysteresis 0.01 to 99.99% 0.02 Default
Level 2 ALH3 Alarm 3 Hysteresis 0.01 to 99.99% 0.02 Default
Level 2 Cn5H Input Shift Upper
Limit
-199.9 to 999.9
°C 0.0 Default
Level 2 Cn5L Input Shift Lower
Limit
-999.9 to 999.9
°C
0.0 Default
Mode Parameter Setting range
Default
Factory
setting
Setup Cn-E Input Type 0 to 21 2 3
Setup
Cn-H Scaling Upper
Limit
Scaling Lower Limit +1 to 9999 EU -100 Default
Setup
Cn-L Scaling Lower
Limit
-1999 to SP Setting Upper Limit -0.1 EU 0 Default
Setup dP Decimal Point 0 to 3 0 Default
Setup d-U
°C/F Selection °C/F °C °F
Setup CnCE Parameter Yes/No No Default