System operation, Remote arming/locking, Remote disarming/unlocking – ScyTek Electronics Galaxy 5000RS-DBP User Manual
Page 23
Galaxy 5000RS-DBP - Page 19
Remote Arming/Locking
The system monitors 5 independent areas (
zones) while armed: doors, hood/ trunk, shock sensor, optional
sensor input, and the network port for future expansion.
To Arm and Lock the System:
1. Turn off the ignition.
2. Press Button 1.
· The siren/horn will chirp/honk once.
· The doors will lock.
· The parking lights will flash once.
· The LED will turn ON, to indicate the starter defeat is activated.
3. 10 seconds after Arming/ Locking:
· The LED will start blinking to indicate that the doors, hood, trunk and sensor inputs are being
monitored.
* During Arming, if the system detects a bad sensor or an open zone, the system will chirp 4 additional
times and ignore that input, but keep all other areas protected.
Once Armed, the alarm will trigger when any of the following occurs:
·
The doors are opened.
·
The hood or trunk is opened.
·
The shock sensor detects an impact to the vehicle.
·
An optional sensor is disturbed.
When the alarm triggers, the siren will sound, the horn will honk, and the parking lights will flash. If
the system is triggered by the doors, hood, or trunk, the system will alarm for 45 seconds. If triggered
by the sensor inputs, the system will alarm for 30 seconds.
In the event the alarm is triggered and remains triggered continuously by the same sensor or input
during a single arming cycle, that sensor or input will be automatically bypassed until the next time
the system is armed.
If the Shock Sensor detects a light impact to the vehicle the siren will chirp 5 times as a warning
indication.
Remote Disarming/Unlocking
To Disarm and Unlock the System:
Press Button 2.
· The siren/horn will chirp/honk twice.
· The doors will unlock.
· The parking lights will flash twice.
· The dome light will turn on.**
· The LED will turn off.
* During Disarming, if the system was triggered while away from the vehicle, the siren will chirp 3 times and the LED
will flash to indicate triggered zone. See
Tamper Alert for zone listing.
** If the Optional Dome Light Activation feature is installed.
System Operation