ROTRONIC CF8-W-Disp-AL - Manual (Page 4)

Dokument
IMA 210 Rev
1 Page
4 (6)
No
Connection
Terminal
Function Electrical Data Remarks
1
2
Power (+)
Power ground (-)
24 VAC/DC+ (+-20%),
3W
24 VAC/DC-
2W without output load
See note 1!
3
4
5
Out(1)
Out(2)
Unmarked
Analogue Output
1 (+)
Analogue Output
2 (+)
Signal Ground (-)
0-10 VDC or 0-20 mA
2-10 VDC or 4-20 mA
0-10 VDC or 0-20 mA
2-10 VDC or 4-20 mA
Connected to via
PTC fuse
According to positions of
OUT1 and start point
jumpers.
See note 2!
According to positions of
OUT2 and start point
jumpers.
See note 2!
See note 1!
6
7
8 NO1
COM1
NC1
(OUT3)
Relay1 Normally
Open
Relay1 Common
Relay1 Normally
Closed
Contact free relay
minimum load 1mA/5V
rated load
0,5A/125VAC;
1A/24VDC
Standard
Open < 1.4 % CO
2
Closed > 1.5 % CO
2
The relay output is potential
free
9
10
11
NO2
COM2
NC2
(OUT4)
Relay2 Normally
Open
Relay2 Common
Relay2 Normally
Closed
Contact free relay
minimum load 1mA/5V
rated load
0,5A/125VAC;
1A/24VDC
Standard
Open < 2.9 % CO
2
Closed > 3.0 % CO
2
The relay output is potential
free
Communi-
cation
jumper
Used to set
communication
protocol
Upper Modbus communication
protocol
Table I. Electrical terminal connections for CF8-W-Disp-AL
Note 1: The ground terminal is used as negative power supply DC input or AC phase ground
(halfwave rectifier). The signal ground M, protected by a PTC resistor, is the same as power ground
G0 (permitting a ”3-wire” configuration). A single transformer may be used for the entire system.
Note 2: CF8-W-Disp-AL can deliver a voltage or a current loop for Out(1)/Out(2). To change between
voltage and current output mode the hardware jumpers are used. There is one jumper for Out(1) and
one for Out(2), so that one output can be a voltage output and the other a current output. Both, voltage
output and current output, can have start points 0 % (0-10 VDC or 0-20mA) or 20% (2-10 VDC or 4-
20mA). The same start point is used for both outputs. See the user manual.
~
+