Noby UK Noby-65 - Manual (Page 11)

Noby-65 Installation Manual & Operating Instructions (Rev.1) Page 11 of 12
USER OPERATING INSTRUCTIONS
Exit Procedure:
Full-Set:
• Check that only the green Power LED is lit.
• Turn the Keyswitch to FULL-SET.
• All LEDs illuminate for 2 seconds, followed by a continuous Exit Tone.
• Proceed directly to the Final Exit Door. Do not stray off the Exit Route.
• Leave the premises and listen for the Exit Tone to stop.
Part-Set:
• Check that only the green Power LED is lit.
• Turn the Keyswitch to PART-SET. Zone-2 is isolated and the Zone-2 LED will flash slowly.
• All LEDs illuminate for 2 seconds, followed by a continuous Exit Tone.
• Proceed directly through the Exit Route to the night-time living area (Zone-2).
• Listen for the Exit Tone to stop.
Note: All existing alarm conditions must be clear before attempting to arm the intruder system.
The Noby-65 will abort the Exit procedure in the event of a system fault or alarm, and the buzzer will
emit a rapid pulsing tone. Perform a System Reset to clear the LEDs and try again.
Entry Procedure:
• Open the Final Exit Door. A slow pulsing Entry Tone will commence.
• Proceed immediately to the Noby-65 control panel. Do not stray from the Entry Route
• Turn the Keyswitch to OFF. The Entry Tone will stop.
Following an Intruder Alarm:
• Turn the Keyswitch to OFF. The Siren and Internal Buzzer will silence.
• Observe and note the red LEDs.
• Perform a System Reset.
To clear latched PIR LED indications:
• Turn the Keyswitch to FULL.
• Allow the Exit Time to finish.
• Turn the Keyswitch to OFF.
System Reset:
• Momentarily turn the Keyswitch to FULL and then to OFF within 2s.
• Observe a 2s LED test.
Note: If the cause of an alarm still persists then the alarm will re-trigger immediately following a System Reset.
To Silence the Alarm:
• Turn the Keyswitch to FULL for 4 seconds.
• Turn the Keyswitch to OFF.
Following a Fire Alarm or Water Alarm:
• CARRY OUT THE PRESCRIBED EMERGENCY PROCEDURE
Only when it is safe to continue:
• Silence the alarm.
• Observe and note the red LEDs, which will identify the cause of the alarm.
• Perform a System Reset.
Cleaning:
Clean external surfaces with a damp cloth and mild detergent. Do not use abrasives, solvents or polish.