Nilfisk-ALTO L-16 - Manual (Page 17)

- MAIN INSERT 50
1 2
3
+4dBu
MAIN INSERT MAIN MIX OUTPUT (BAL/UNBAL)
L L
CTRL OUT DFX OUT MONO RING RETURN
TIP SEND
0
FOOT SWITCH
R R
(BAL/UNBAL)
L
LEVEL
OUTPUT
MAIN
-30dBu
L
R R
- +15 8
1 2
3
These 1/4" phone sockets will be used to send the control room signal to the Studio Monitor speakers or a se-
cond set of PA.
- CTRL OUT 53
This 1/4" phone socket is used to output the effect signal that comes from internal DSP module and the signal
can be controlled in level by EFFECTS OUT control.
- DFX OUT 54
55 - FOOTSWITCH
This 1/4" phone socket can be used to connect an external footswitch to turn on/off the onboard effect module.
This 1/4" phone socket is balanced/unbalanced mono mix output connector, it can be regarded as a sum output
of the left and right of MAIN MIX.
- MONO OUTPUT 51
This knob sets the level of mono mix output signal, which can be varied from - to +15dB.
- MONO LEVEL 52
48
49
50 51 52
54
55 53
- MAIN MIX OUTPUT 48
This button sets the main mix output level to match the input of the device that you are ready to connect. Engage
this button to reduce the output level from MAIN MIX OUTPUT by 30dBu, it used to match the semipro -30dBu
device, on the contrary, to match the professional +4dBu device.
- MAIN OUTPUT LEVEL 49
16
These two 1/4" phone sockets are stereo insert points and used to connect processors such as compressors,
equalisers etc.. When insert a external processor into the jack, the Main stereo signal will be taken out after the
EQ and returned into the MAIN MIX output before the MAIN MIX fader.
This stereo output is supplied with both the XLR and 1/4" phone sockets and it is controlled by the Main Mix
Level.