Nilfisk-ALTO L-16 - Manual (Page 16)

12V 0.5A
LAMP
L
TAPE IN
R
TAPE OUT
2-TRACK IN/OUT
- 2-TRACK IN/OUT 43
TAPE IN
Use the Tape input if you wish to listen to your Mix from a Taper
Recorder or DAT. You can assign the signal coming from the
Taper Recorder either to a pair of studio monitor using the
Control Room assignment on the front panel or you can also
send the signal directly to the Main Mix.
TAPE OUT
These RCA jacks will route the main mix into a tape recorder.
These sockets will send out the monitor signal to a pair of headphones.
45 - PHONES
- LAMP 44
43 44
B
PHONES
A
Useonly witha 250Vfuse Useonly witha 250Vfuse Useonly witha 250Vfuse
PHANTOM POWER
ON
OFF
AC INPUT
EUROPE
210-240V
50Hz
RATED POWER CONSUMPTION: 65W
Fuse:T500mAL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
4.12 REAR PANEL Description
45
46 - POWER ON/OFF switch
This switch is used to turn the Main Power ON and
OFF.
4 - PHANTOM ON/OFF switch
47 - AC inlet with fuse holder
Use it to connect your L-16 to the Main AC with the
supplied AC cord. Please check the Voltage available
in your Country and how the Voltage for your L-16
is configured before attempting to connect your L-16
to the Main AC.
46
47
4
15
This lovable LAMP is very convenient for your operation, it is located in the top right corner of the front panel,
and provides the 12V socket that can drive any standard TNC-type lamp. Please use the customized gooseneck
lamps, the GL-SQ and GL-RO are both options.
This switch will apply +48 Volt Phantom Power only
to the 10 XLR microphone inputs. Never connect
microphones when the Phantom Power is on already.
UK / Aust
240V 50Hz
Fuse:T500mAL
USA / Canada
100-120V 60Hz
Fuse:T800mAL