Blue-White FLEX-PRO A4 ProSeries Peristaltic Pump - Manual (Page 11)

Manual Speed Adjust
OFF
Manual Speed Adjust
Press START to run
Peristaltic Metering Pump
Industries, Ltd.
ProSeries
by Blue-White Ind.
d
Peristaltic Metering Pump
Industries, Ltd.
ProSeries
by Blue-White Ind.
d
Page 11 Flex-Pro
7.0 Pump Output Speed Adjustment
Press UP arrow to increase pump output. Press DOWN arrow to increase
pump output.
Pressing the START button
repeatedly will toggle the
display to indicate the
%SPEED, RPM, and Tube
Timer Hours.
Tip!
Manual Speed Adjust
GAL/DAY
228
Е Й
ДИ
Displays current rotor direction
Manual Speed Adjust
RPM
62
Е Й
ДИ
Manual Speed Adjust
%SPEED
70.8
Е Й
ДИ
186
PUMP TUBE TIMER
Enter twice to reset
Current tube timer:
Hrs.
Tube Timer Displays
for 4 seconds.
- Contact Closure Input
Close: Stop Pump
Open: Stop Pump
Disable
Done
8.0 Contact Closure Input (Remote Start/Stop)
Used to remotely start and stop the pump using a close=stop or open=stop
signal. If the pump must start when the loop is open, then select “Close: Stop
Pump” option. Can be used with an external foot pedal, a PLC, contact closure,
or other similar external devices.
Default settings: Disable
CC Input Range: 6 - 30 VDC
or
Dry Contact Closure (no voltage required)
[See section 5.1 for wire connections]
Navigate to Contact Input menu by holding the START button for 5 seconds.
Press UP or DOWN arrow to scroll through your options.
Press START to make a selection. The radio button (square box) is now filled in
next to your selection.
Press DOWN arrow to scroll down to Done selection. Then press START.
IMPORTANT: To begin operation, press the START button to place pump in
STANDBY. The display background will turn blue indicating the pump has been
stopped remotely. When the pump is started by the remote contact, the display
background will turn green.
IMPORTANT: If the Contact Closure Input is enabled, the pump will display
STANDBY if the pump has been stopped by the Remote Contact Closure.
Please use caution in this mode as the pump may Start at anytime. If you
must perform maintenance to the pump, Press STOP button.
When Contact Closure Input is enabled, the word Remote will always be
displayed on the lower left side of the display screen.
Manual Speed Adjust
Waiting for SIGNAL...
STANDBY
REMOTE
Manual Speed Adjust
GAL/DAY
228
Е Й
ДИ
REMOTE
Signal stopped pump
Signal started pump