Audient ASP8024 Dual Layer Control Module - Manual (Page 9)

Page -9- © Audient Ltd
Automation Setup - A Note
Please note that it is not possible to run the ASP2802 analogue
fader automation as a HUI
TM controlled device within Cubase
alongside a HUI TM based control surface.
However if you are not using the ASP2802 as a control
surface within Cubase / Nuendo (i.e you have another
controller that is not HUI
TM based such as a Euphonix MC),
you can trick the automation system into responding to HUI TM
data to take advantage of Cubase / Nuendo’s automation
modes when using the ASP2802 analogue automation.
To do this set the console into Logic mode (setup menu >
host software).
Configure 8 mono dummy audio tracks at the start of your
Cubase / Nuendo session that contain no audio.
In the device setup menu of Cubase / Nuendo, setup a single
HUI
TM remote device MIDI controller to address the ASP2802
Automation MIDI input and output ports.
Fix the controller to the first 8 dummy audio tracks by placing
them at the start your session and now enjoy access to all
automation modes within Cubase / Nuendo.
• Auto Read
• Auto Touch
• Auto Latch
• Auto Write
• Auto Off