American Comfort GMCN 100 Series - Manual (Page 7)

1-877-645-0299 www.AmericanComfort.com 5
Installation Instructions
ATTENTION:
a) Before you start, place the unit on a firm, level surface where there is a grounded 115 V/60 Hz
power outlet nearby. Only operate in an upright position. Do not use an extension cord.
b) Ensure you have space for air to flow around the unit, a t least 30cm/12” from wall, curtains,
draperies, or heat sources to insure adequate air circulation. Any blockage can lead to
overheating of the air conditioner.
c) Handle with care to prevent any kink or bend in the exhaust hose.
d) The flexible exhaust hose can be extended from 12" to 60" for mounting. We recommend that
you keep the hose as short as possible to minimize possible loss back in the room.
The unit is a portable air conditioner that may be moved from room to room.
Note: The window kit is only designed to be installed with sliding windows or doors. The
window kit is not designed or to be used with casement style windows.
Assembling the Adaptor and Hose
1. Insert the exhaust adaptor from left to right
into the slot at the back of the unit.
2. Push downward to lock the adaptor then spin
in the threaded hose.
Installing the Outward Adaptor and Window Slide Bar
3. Install and extend window slide bar to fit your window opening, either vertical or horizontal,
depending on how the window opens. See Figure 7.
4. Install the hose to the outward adaptor
and snap the hose connector into the
window slide bar opening as shown.
Please make sure the hose is firmly
attached to the connector that fits into
window slide bar.
.
Installing directly through a wall/window
Cut a 130mm diameter hole in the wall or window, and then feed
exhaust hose through the window or wall.
Figure 6
Figure 7
Figure 8