Amerex 18764 - Manual (Page 12)

Manual 18764 Rev - Page 12
The following installation instructions should be followed to avoid hose twisting and kinking as
the hose is coiled on the retention rack.
Lay the hose straight on the ground
The second loop is a “reverse”
to its full 40’ length. Start the first loop loop. Note that the hose passes
counter-clockwise by placing it over the behind the loop on this coil.
retention bracket as shown.
The next loop is a regular “hose in front”
Adjust loops so that the nozzle fits
loop. Succeeding loops are alternated, into the nozzle mount. Loops should
reverse, front, etc. until the hose is installed. be approximately the same length.