Time Electronics 1090 Portable Process Calibrator - Manual (Page 5)

5
1090 Technical Manual P a g e | 5
Secondary functions are shown in [ ]
A 4mm Output Terminals
B 4mm Input Terminals
C Chassis earth connection
D 16 digit Liquid Crystal Display
E Increments output in accordance with user set resolution
F Decrements output in accordance with user set resolution
[Turns unit off]
G [Selects Type S thermocouple]
H [Selects Type R thermocouple]
I [Selects Type K thermocouple]
J [Selects Type J thermocouple]
K [Selects Type B thermocouple]
L [Selects mV]
M [Selects mA]
N [Selects uV]
P In source mode recalls values stored in memory
[Stores values in memory]
Q Steps to the next stored value
[Auto steps]
R [Selects Type T thermocouple]
S Allows menu functions to be viewed and changed
[Toggles the temperature readout between o
C and
o
F]
T [Selects Type N thermocouple]
U [Selects Source or Measure]
V [Selects Type E thermocouple]
W Clears value
X Enters an output value.
[Selects PRT (RTD) mode]
Y Sets keypads to secondary (RED) functions
Note: The secondary keypad functions are available only when relevant to the selected
operating mode eg ’Auto Step’ is not available when the 1090 is in measure mode.
Also please note that the ’SHIFT’ mode has an automatic time out. This means that it will
automatically be cancelled if the secondary function is not selected within a few seconds.