Thermo Fisher Scientific Alpha COND 1000 - Manual (Page 14)

Operating Instructions Thermo Scientific Alpha COND 1000
6
4.2 Function Groups
The main function and sub-function groups are organised in a matrix format for
configuration and selection of parameters. The main function groups are:
1) Temperature Coefficient settings (
tc ). See Section 7.1.
2) Temperature Measurement / compensation settings ( SEt
o
C ). See Section 7.2.
3) Control relay 1 configuration ( SP1 ). See Section 7.3.
4) Control relay 2 configuration ( SP2 ). See Section 7.3.
5) Control type ( Cntr ). See Section 7.4.
6) Current output ( rng ). See Sections 7.5 & 7.6.
7) Configuration ( ConF ). See Section 7.7.
8) Calibration ( CAL Con ). See Sections 6 & 7.8.
HOLD SETUP HOLD SETUP HOLD HOLD SETUP SETUP
Sp1 Sp2
HOLD SETUP
° C
HOLD SETUP
Cal
HOLD SETUP HOLD SETUP
C
The set-up parameters can be viewed or changed by entering a security code. See
Section 5.2 for security code information.
4.2.1
How to view operating parameters without access to change them:
a) Press
the ENTER key. The display will prompt the
user to enter a security code (S.Cd). Leave the
security code at “000” (do not enter a security code).
b) Press ENTER key again. This allows you only to
view (not change) any sub-functions’ settings.
c) Press the ▲ or ▼ keys to scroll through the sub-
functions.
d) Press the ENTER key at a particular sub-function to view in detail.
e) Press the ENTER key to return to the sub-function menu.
f) Press the ▲ or ▼ keys simultaneously (as an Escape key) at any time to return
to the Measurement mode.
Note: To simplify operations, the controller will not display parameters that are not
relevant to a particular sub-function. For example: If the user set the controller for
Limit control, it will not display pulse length/frequency settings.
000