Techne TC-3000X - Manual (Page 46)

44
Controller reset
The 'Controller reset' will delete all saved
programs from the unit.
Highlight 'Controller reset' then press
"Enter"
To delete all the programs, press "Enter"
RUNNING THE TC-3000 & TC-3000X FROM A PC
The thermal cyclers can be run from a PC using Bibby Scientific Ltd's Gensoft software. This is available
to download from the Techne web-site at www.techne.com. Instructions for using Gensoft are included
in a separate manual.
Connecting one unit to the computer using an RS 232 cable
If you are driving one TC-3000 unit you will need part number FGEN232 which includes a 9-pin female
to female, null modem, RS232, fully screened cable, Gensoft on disk and an instruction sheet. To connect
a single TC-3000X unit, connect the unit to the PC using the USB cable, part number 6205046.
Program defaults
Settings
Passwords
Controller reset
CONTROLLER RESET
This will delete
all programs
[ SURE ? ]
[ Yes or No ]
TC-3000 TC-3000X