Liquid calibation baths (lcb) reference card – Techne Liquid Calibration Bath User Manual
Page 2
Liquid Calibation
Baths (LCB)
Reference Card
WARNING
Warning: HIGH TEMPERATURES ARE DANGEROUS
Avertissement: DANGER DE TEMPERATURES ELEVEES
Warnung: HOHE TEMPERATUREN SIND GEFÄHRLICH
Aviso: LAS TEMPERATURAS ELEVADAS SON PELI
Contact Information
For technical, sales or servicing information, contact your local
Techne dealer or,
Barloworld Scientific Ltd
Beacon Road, Stone
Staffordshire
ST15 0SA, United Kingdom
Telephone:
+44(0)1785 812121
Fax:
+44(0)1785 813748
e-mail:
or,
Techne Inc, 3 Terri Lane,
Suite 10, Burlington,
New Jersey 08016, USA.
Telephone:
609-589-2560
Toll free:
800-225-9243 ext 306
Fax:
609-589-2571
e-mail:
Web site:
www.techneusa.com
Issue 5
Date of issue:
3rd May 2005
Techne is a trade mark
© Techne 2002
Additional Information
NOTE THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED
BY PROPERLY TRAINED PERSONNEL. REMOVING THE TOP
CASE EXPOSES POTENTIALLY LETHAL MAINS VOLTAGE.
THERE ARE NO OPERATOR MAINTAINABLE PARTS WITHIN
THE EQUIPMENT.
In the unlikely event that you experience any problems with
your Thermoregulator which cannot easily be remedied, you
should contact your supplier and return the unit if necessary.
Please include any details of the fault observed and remember
to return the unit in its original packing. Techne accept no
responsibility for damage to units which are not properly
packed for shipping: if in doubt, contact your supplier.
Operator maintenance
1.
Cleaning
Before cleaning your unit ALWAYS disconnect from the
power supply and allow to cool below 50
° C.
Your Thermoregulator can be cleaned by wiping with a
damp soapy cloth. Care should be exercised to prevent
water from running inside the unit. Do not use abrasive
cleaners.
2.
Overtemperature cut-out
The overtemperature cut-out is a sensitive mechanical
device and mechanical shock can cause it to trip.
•
In the event of no heater power, check the mains plug and
lead, then reset the cut-out control.
•
Repeated operation of the cut-out indicates a serious fault:
you may need to return the unit to your supplier for repair.
3.
Fuses
Your unit is protected by two fuses.
For the approriate fuse see the User's Manaul for the unit.
These should only be changed by suitably qualified
personnel.
If the fuses blow persistently, a serious fault is indicated
and you may need to return the unit to your supplier for
repair.
Accessories
There are many accessories both for the thermoregulators
and the baths. These are constantly being updated and
details can be found in Techne Sales literature. However they
do include:
Flow Coolers
FFC2D
FC-200 230V UK
FFC2D
FC-200 230V Europe
FFC2P
FC-200 120V
FFC5D
FC-500 230V UK
FFC5D
FC-500 230V Europe
FFC5P
FC-500 120V
FTU232 "Thermsoft" kit inc: disc, cable and
connector for TU-20C