Altinex MT110-100/102 - Manual (Page 26)

MULTITASKER™
400-0132-005 25
Solution 2: Set the volume of the destination
amplifier to a reasonable level. If
there is still no sound, call ALTINEX
at (714) 990-2300.
8.4. DISTORTED SOUND
Cause 1: The source level is above 1Vp-p
Solution: Make sure that the source level is
below 1V p-p. If the sound is still
distorted, see Cause 2.
Cause 2: The destination amplifier
provides excessive amplification.
Solution 1: Make sure that the source signal
level is high enough so that the
destination amplifier does not have
to provide excessive amplification
and thereby distort the signal. If
there is still sound distortion, see
Solution 2.
Solution 2: Call ALTINEX at (714) 990-2300.
8.5. SOUND LEVEL IS LOW
Cause 1: Volume levels are inappropriate.
Solution 1: Turn up the source volume. If sound
level is still low, see Solution 2.
Solution 2: Turn up the destination amplifier
volume. If the sound level is still low,
see Cause 2.
Cause 2 Poor signal transmission.
Solution: Check the cables for continuity and
make sure that connections are
wired properly to verify that there is
good signal transmission.
NOTE: Test the system by removing
the MT110-100/102 card
from between the source and
the destination amplifier. If
the problem persists, call
ALTINEX at (714) 990-2300.
ALTINEX POLICY 9
9.1 LIMITED WARRANTY/RETURN POLICY
Please see the Altinex website at
www.altinex.com for details on warranty and
return policies.
9.2 CONTACT INFORMATION
ALTINEX, Inc.
592 Apollo Street
Brea, CA 92821 USA
TEL: 714 990-2300
TOLL FREE: 1-800-ALTINEX
FAX: 714-990-3303
WEB: www.altinex.com
E-MAIL: [email protected]