Revo REVDN650-1 - Manual (Page 8)

7
CAMERA CONNECTIONS
Connection Cable Description
COLOR Description
RED AC24V/DC12V
WHITE AC24V/DC12V
ORANGE ADKEY
BROWN GND
BLUE RS485(-)
GREEN RS485(+)
YELLOW ALARM OUT
GRAY DN EXT-IN
BLACK&WHITE DN EXT-OUT
BLACK GND
SKY BLUE UTP+(optional)
PINK UTP- (optional)
1) External Day/Night Control : To select Day/Night mode using external equipment,
by connecting control lines to the appropriate terminals.
¾ DAY&NIGHT OUTPUT (Black&White)
Is the camera function that can turn on an external IR LED Lamp by detecting
the sensitivity on the AGC level when the D&N mode is set "AUTO" on the
OSD menu of the camera
¾ DAY&NIGHT EXTERNAL INPUT (Gray)
Is the camera function that can be switched to DAY Mode or NIGHT mode by
receiving the D&N on/off signal from external light sensor or IR LED LAMP.
This needs the D&N Mode to be set to "External" on the OSD menu of the
camera to work
2) Alarm Out
¾ Motion detection signals are output through this port. (YELLOW AND GND)
¾ Active state is configurable.
3) Power Input Terminal
¾ RED & WHITE : DC Power is recommended to use the DC power supply that can
support inrush current over 0.75A
4) Camera Control
¾ GREEN : RS 485+
¾ BLUE : RS 485-
5) UTP (optional)
¾ Video signal through out the UTP Cable (SKY BLUE(+) & PINK(-) )
DAY&NIGHT INPUT Gray
GND Black Close contact: NIGHT
Open contact: DAY
̻
̻
GND Black
DAY&NIG Black&White ̻ 5V/10mA : IR LED ON (NIGHT)
̻ 0V : IR LED OFF (DAY)