Camera configuration, Getting started – Revo RELPTZ22-1 User Manual User Manual
Page 22
REVO America
www.revoamerica.com
RELPTZ22-1
20
C
C
a
a
m
m
e
e
r
r
a
a
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Now that the system is installed, your next step is to configure the camera for operation. These
instructions will guide you through optimizing the camera for use and setting it up for your
installation. You can customize the camera’s movements and many other functions using the
camera’s menu system. Please note that for most applications, the default settings that your
REVO America camera has will work just fine and should not require any further adjustment.
For the purposes of describing the commands and configurations available on the camera, all
commands and operation of the camera will be initiated using a REVO America keyboard
controller. This is the ideal setup and offers the greatest flexibility and ease of operation. However,
a REVO America DVR may also be used to control the camera, as well as non REVO America
keyboard controllers or DVRs, which may be used providing you set the protocols correctly. See
the Settings section. Refer to the applicable user manual to determine the equivalent command
keys on your device.
Getting Started
Once the system is fully connected, apply power. The DVR, camera and keyboard controller will
begin a boot up routine. This will take a few minutes. Once the system is fully powered up, you
should see the following.
001
AF AE
CAMERA VIDEO
DOMEID:
001
ALARM:
1
W→
360.0,090.0
ALARM DISPLAY
VIEW DIRECTION
PAN & TILT ANGLES
PRESET TITLE
AREA TITLE
FOCUS STATUS
EXPOSURE
STATUS
CAMERA TITLE
CAMERA ID